Roverpet F24 Assembly Instructions

Roverpet

Roverpet #F24 – 2'x4' Floor Assembly Instructions

Inventory List for The Roverpet #F24 2' x 4' Sealed PVC Floor:

(1) #F24 2'x4' PVC floor for 2'x4' pet cage AND/OR (2) #F24 PVC floor for 4'x4' pet cage

(6) #250 floor clips for each included floor

Assembly Procedure

1.) Unpack contents of shipping carton and compare to inventory list above.

2.) Place the #F24 floor, flat side down, on your floor. Make sure the #F24 floor is resting completely flat on your floor

surface.

3.) Place your existing Roverpet dog cage over the floor, with the flat side facing down. The Roverpet dog cage will rest on

the outside of the #F24 floor frame.

4.) With the Roverpet dog cage positioned over the #F24 floor, install (1) #250 floor clip in the middle of each PVC panel.

Snap the clip over the panel frame and #F24 floor frame, securing the panel to the #F24 floor.

20 Kiji Dava Circle Prescott, Arizona 86301

800-658-5925

Page 1 of 2 Floor Assembly

rover@roverpet.com

Table of Contents

Do you have a question about the F24 and is the answer not in the manual?

Page 1 Assembly Procedure 1.) Unpack contents of shipping carton and compare to inventory list above. 2.) Place the #F24 floor, flat side down, on your floor. Make sure the #F24 floor is resting completely flat on your floor surface. 3.) Place your existing Roverpet dog cage over the floor, with the flat side facing down. The Roverpet dog cage will rest on the outside of the #F24 floor frame.
Page 2 5.) For multi-floor pet crates: Install (4) #250 floor clips over the #F24 floor frames where they meet together. Place (2) #250 floor clip at the furthest most points of the #F24 frames and (2) more #250 floor clips evenly spaced across the two #F24 floor frames.