Quick Start Guide Foreword General This manual introduces the functions, installation and operations of the camera. Safety Instructions The following categorized signal words with defined meaning might appear in the manual. Signal Words Meaning Indicates a high potential hazard which, if not avoided, will result in death or serious injury.
Page 3
Quick Start Guide Upgrade the reader software or try other mainstream reader software if the manual (in PDF format) cannot be opened. All trademarks, registered trademarks and the company names in the manual are the properties of their respective owners. Please visit our website, contact the supplier or customer service if there is any problem ...
Quick Start Guide Important Safeguards and Warnings Electrical safety All installation and operation should conform to your local electrical safety codes. The power source shall conform to the Safety Extra Low Voltage (SELV) standard, and supply power with rated voltage which conforms to Limited Power Source requirement according to IEC60950-1.
Page 5
Quick Start Guide It is recommended connect the grounding hole to the ground to enhance the reliability of the device. Do not touch the image sensor directly (CMOS). Dust and dirt could be removed with air blower, or you can wipe the lens gently with soft cloth that moistened with alcohol. Device body can be cleaned with soft dry cloth, which can also be used to remove stubborn ...
Quick Start Guide Cable Cable type might vary with different devices, and the actual product shall prevail. Please waterproof all the cable joints with insulating tape and waterproof tape to avoid short circuit and water damage. For the detailed operation, see the FAQ Manual. Cable list For more information about cable ports, see Table 1-1.
Quick Start Guide Network Configuration Device initialization and IP setting can be finished with the "ConfigTool" or in web interface. For more information, see the Web Operation Manual. Device initialization is available on select models, and it is required at first use and after device is ...
Quick Start Guide The Device initialization interface is displayed. Select the devices that need initialization, and then click Initialize. The password setting interface is displayed. See Figure 2-2. Password setting interface Set and confirm the password of the devices, and then enter a valid email address. Click Next.
Quick Start Guide Select the devices which IP addresses need to be modified, and then click Modify IP. The Modify IP Address interface is displayed. See Figure 2-3. Modify IP address interface Select Static mode and enter start IP, subnet mask and gateway. IP addresses of multiple devices will be set to the same if you select Same IP.
Quick Start Guide Installation Packing List The tools required for the installation including electric drill is not provided in the packing. The operation manual and related tool are contained in the disk or the QR code, and the actual ...
Quick Start Guide Installing Device 3.3.1 Installation Method Installation Type Wall-mounted Pole-mounted Corner-mounted Ceiling-mounted 3.3.2 Installing SD Card (Optional) SD card slot is available on select models. Model A and Model B are defined according to the location of the SD card slot. Please disconnect the power from the device before installing the SD card.
Quick Start Guide 3.3.3 Attaching Device Make sure the mounting surface is strong enough to hold at least three times of the device weight. Cable going through the wall...
Quick Start Guide Cable going through the side cable tray 3.3.4 Installing Waterproof Connector This part is only needed when a waterproof connector comes with the device and the device is used outdoor.