Advertisement
C
HANGES IN THE USER MANUAL OR IN THE CONTROLLER
Version of the
user manual
2.2
1.
2.
3.
4.
this mode, browsing all the menus is not by pressing the F button, but by
pressing the arrow buttons.
previous.
5.
restricted up to 1 minute.
2.4
1. The software version is changed to 3.2/3.1
2. After an unsuccessful ignition try, on every next attempt, the portion of
loaded fuel will be half of the amount of the previous one. This helps to
prevent the jam up of the burner with fuel after few unsuccessful ignition
attempts.
3. An option to power up the FC output during the Intermediate cleaning
procedures. This output may supply power to a device for periodical
mechanical cleanings of the burning chamber.
4. An option to set constant active time for the internal auger motor in
addition to its active time that depends on the fuel auger's active time.
5. Increased maximum work time of the cleaning fan during the cleaning
cycles (FC output) – from 60 to 600 seconds. Adjustment step is changed
to 10 seconds.
2.5
1. The software version is changed to 3.3a/3.2
2. The appearance of the error messages is changed
3. Decreased maximum work time for the cleaning fan during the
cleaning cycles (FC output) from 600 to 250 seconds. Adjustment step is
changed to 1 second.
4. Overheating menu
5. Changes in the Intermediate Cleaning menu
6. Changes in the Auto Clean Setup menu
7. Cleaner menu – delay option after cleaning procedures, useful for
mechanical cleaning actuators
8. External Stop function
User Manual / version 2.6
Electronic pellet burner controller - NPBC-V3M
The software version is changed to 3.0/3.0
Different control logic of the circulation pumps of the installations.
Included Bulgarian language
A new way of operation in Service settings mode. After entering
After turning the burner off, the work of the internal auger motor is
http://www.naturela-bg.com/en/
Changes
▲
shows the next menu and
'
S SOFTWARE
Page
▼
- the
page 2 of 27
1
7, 8
14
15
1
12
19
20
1
10
15
19
19
20
21
21
Advertisement
