Advertisement
cleaning cycle after extinction. These settings also apply for the intermediate automatic cleanings.
Cleaning after extinction caused by Back Burning alarm – Cleaning on BB – sets the work time
for the main (Fan) and the additional (Cleaner) air fan for the cleaning cycle if a back burning alarm
has been registered.
General Setup -
initial feed (Feed) and the speed of the Exhaust Fan (EFan).
Ignition cycle setup -
and the following two work modes of the fan, which include speed and duration.
User Manual / version 2.6
Electronic pellet burner controller - NPBC-V3M
- set the number of ignition attempts (Retries), the work time of the auger for
Cycle Setup – adjust the work time of the heater before the fan turns on
http://www.naturela-bg.com/en/
The heater works for 30 sec.
before the fan turns on
After that, along with the
heater, the fan works for 2
min. on 5% of its power
Next 3 min., along with the
heater, the fan works on
15% of its power
page 16 of 27
Advertisement
