Controls Explained; Weld Process Selection; Mig Process; Stick (Mma) & Tig Process - Weldclass Weldforce 210MST Operating Instructions Manual

4.1 Weld Process Selection

1. Press and hold the 'Top Selection Knob' (21) until the current Welding Process Indicator Lights
(24) beings flashing.
Figure 7
2. Rotate the 'Bottom Selection Knob' (22) until the desired Welding Process Indicator Light (24) is
flashing.
Figure 8
3. Press the 'Top Selection Knob' (21) to select the process.

4.1.1 MIG Process:

In Manual MIG mode (MAN) – the 'Top Selection Knob' (21) adjusts wire speed and the 'Bottom
Selection Knob' (22) adjusts the voltage.
In Synergic (Auto) MIG mode (SYN) – the 'Top Selection Knob' (21) adjusts material thickness and the
'Bottom Selection Knob' (22) adjusts the inductance.
4.1.2 Stick (MMA) & TIG Process:
The 'Top Selection Knob' (21) amperage and the 'Bottom Selection Knob' (22) is disabled.

4 CONTROLS EXPLAINED

3 sec