Home Decorators Collection 301353180 Use And Care Manual page 15

Operation
Operation
NOTE:
The control panel can be accessed at the upper-right corner of the insert.
1
Powering the fireplace
Push the Power button to supply power to all
functions of the fireplace and put the insert in
standby mode.
Push the Power button again to turn off all functions.
NOTE:
All previous settings are held in memory, so the
next time you power up the fireplace, the unit will turn on
with the same settings.
NOTE:
Holding the Power button on the control panel for
10 seconds will disable the heater function.
3
Adjusting the heater
Press the Heater button to set the thermostat. The fireplace
contains three infrared quartz heating elements.
The thermostat setting range is 62°F - 82°F or 17°C - 27°C
or always ON.
The thermostat is adjustable by 2°F or 1°C increments.
The up and down buttons"
increase / decrase temperature setting.
NOTE:
To change between °F and °C press and hold the
HEATER button on the control panel for 3 seconds.
"on the remote will
/
2
Adjusting the flame
There are 6 brightness levels that can be selected:
Settings F6 - F4 decrease in Amber brightness
Settings F3 - F1 decrease in Spectrafire brightness
4
Setting the timer
Pressing the Timer button will cycle through the timer
settings; 30 minutes, 1 Hour, 2H, 3H, 4H, 5H, 6H, 7H,
8H, 9H and off.
15
Please contact 1-800-986-3460 for further assistance.
HOMEDEPOT.COM/HOMEDECORATORS