Sony WF-C500 Help Manual page 63

Wireless stereo headset

Table of Contents

If it is not displayed, repeat from step

Select [WF-C500] displayed on the screen of the Bluetooth device for pairing.

If Passkey (*) input is required, input "0000".

A Passkey may be called "Passcode", "PIN code", "PIN number", or "Password".

Make the Bluetooth connection from the Bluetooth device.

Some devices automatically connect with the headset when the pairing is complete.

The indicators (blue) on both units of the headset flash quickly for about 5 seconds.

You will hear the voice guidance say "Bluetooth connected" from the unit of the headset that was removed first from

the charging case.

If they are not connected, see

Hint

The operation above is an example. For more details, refer to the operating instructions supplied with the Bluetooth device.

To delete all Bluetooth pairing information, see

Note

If pairing is not established within 5 minutes, pairing mode is canceled. In this case, set the headset into the charging case, and

start the operation again from step

Once Bluetooth devices are paired, there is no need to pair them again, except in the following cases:

Pairing information has been deleted after repair, etc.

When a 9th device is paired.

The headset can be paired with up to 8 devices. If a new device is paired after 8 devices are already paired, the registration

information of the paired device with the oldest connection date is overwritten with the information for the new device.

When the pairing information for the headset has been deleted from the Bluetooth device.

When the headset is initialized.

All of the pairing information is deleted. In this case, delete the pairing information for the headset from the connected device

and then pair them again.

The headset can be paired with multiple devices, but can only play music from 1 paired device at a time.

Table of Contents

Yy2952