Graco Husky 1050HP Repair Parts page 6

Warnings
EQUIPMENT MISUSE
EQUIPMENT EQUIPMENT
Misuse can cause death or serious injury.
• Do not operate the unit when fatigued or under the influence of drugs or alcohol.
• Do not exceed the maximum working pressure or temperature rating of the lowest rated
system component. See Technical
• Use fluids and solvents that are compatible with equipment wetted parts. See Technical
in all equipment manuals. Read fluid and solvent manufacturer's warnings. For complete
information about your material, request MSDS from distributor or retailer.
• Do not leave the work area while equipment is energized or under pressure.
• Turn off all equipment and follow the Pressure
• Check equipment daily. Repair or replace worn or damaged parts immediately with genuine
manufacturer's replacement parts only.
• Do not alter or modify equipment. Alterations or modifications may void agency approvals
and create safety hazards.
• Make sure all equipment is rated and approved for the environment in which you are using it.
• Use equipment only for its intended purpose. Call your distributor for information.
• Route hoses and cables away from traffic areas, sharp edges, moving parts, and hot surfaces.
• Do not kink or over bend hoses or use hoses to pull equipment.
• Keep children and animals away from work area.
• Comply with all applicable safety regulations.
PRESSURIZED ALUMINUM PRESSURIZED PRESSURIZED
Use of fluids that are incompatible with aluminum in pressurized equipment can cause serious
chemical reaction and equipment rupture. Failure to follow this warning can result in death,
serious injury, or property damage.
• Do not use 1,1,1–trichloroethane, methylene chloride, other halogenated hydrocarbon
solvents or fluids containing such solvents.
• Do not use chlorine bleach.
• Many other fluids may contain chemicals that can react with aluminum. Contact your material
supplier for compatibility.
THERMAL THERMAL EXPANSION THERMAL
Fluids subjected to heat in confined spaces, including hoses, can create a rapid rise in pressure
due to the thermal expansion. Over-pressurization can result in equipment rupture and serious
injury.
• Open a valve to relieve the fluid expansion during heating.
• Replace hoses proactively at regular intervals based on your operating conditions.
6
All manuals and user guides at all-guides.com
WARNING WARNING WARNING
MISUSE HAZARD HAZARD
MISUSE HAZARD
Technical Data Technical
ALUMINUM PARTS ALUMINUM PARTS PARTS HAZARD
EXPANSION HAZARD EXPANSION HAZARD HAZARD
Data in all equipment manuals. Data
Pressure Relief Pressure Relief Procedure Relief Procedure when equipment is not in use. Procedure
HAZARD HAZARD
Technical Data Data
Technical Data
334390E