Table of Contents
Advertisement
INSTALLATION
11) Disconnect the wire harness connected to the valve that comes from
the module.
12) Remove the thermodisc cover from the thermodisc plate by undoing
the 2 screws and then remove the wire grommet.
Thermodisc Cover
Grommet
13) Take the black and white wires from the kit and place the grommet
thru the wires.
14) Place the wire grommet back into the thermodisc cover with the 2
female ends of the wires inside the cover as shown.
26
Thermodisc Plate
15) Connect the female ends of the black and white wires to the thermo-
disc.
16) Reattach the thermodisc plate to the thermodisc cover using the 2
screws removed in step 12.
17) Connect the thermodisc wire harness to the new valve/module wire
harness. Refer to the wiring diagram for details.
18) Secure the thermodisc plate to the thermodisc bracket.
Important: Thermodisc location is crucial, check the data badge to
identify unit and secure to screw location accordingly.
19) Remove the left side bottom hinge bracket by undoing the 2
screws.
®
Regency
PG36D Gas Log Fireplace
Advertisement
Table of Contents
