Table of Contents
Advertisement
Quick Links
Single Channel Video Receive Unit with one Bi-directional
Data Channel and one Bi-directional Alarm for a Multimode
The AMG5614 is a standalone system designed to receive one video signal and transmit and receive
one bi-directional alarm plus one data signal over a Multimode optical fibre.
The AMG5614 is designed to be powered using an AMG2001 standalone power supply.
The AMG5614 is designed to operate with an AMG5613 standalone video transmit unit in a point to
point configuration.
AMG Systems Ltd. reserves the right to make changes to this
document without notice. The information herein is believed to
be accurate. No responsibility is assumed by AMG for its use.
Fibre Link
Page 1 of 8
AMG5614
Instruction Manual
AMG5614 Instruction Sheet D17081-
03.doc
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for AMG AMG5614
Summary of Contents for AMG AMG5614
- Page 1 Multimode optical fibre. The AMG5614 is designed to be powered using an AMG2001 standalone power supply. The AMG5614 is designed to operate with an AMG5613 standalone video transmit unit in a point to point configuration.
- Page 2 Removal / replacement from / to the Case..................8 Safety Maintenance and Repair AMG Systems Ltd. reserves the right to make changes to this Page 2 of 8 AMG5614 Instruction Sheet D17081- document without notice. The information herein is believed to 03.doc...
- Page 3 AMG5613. Optical Connection The AMG5614 connections are illustrated in the following example which shows an AMG5613 single channel transmit unit together with a AMG5614 configured as a point to point system. AMG Systems Ltd. reserves the right to make changes to this...
- Page 4 RS-232 – Switch Position - Bottom Alarm Input ..........Contact Closure pull-up is 330R to +3V3 Alarm Output........Solid-state Relay, maximum 150mA at 125Vac/dc, Ron < 6.5Ω AMG Systems Ltd. reserves the right to make changes to this Page 4 of 8 AMG5614 Instruction Sheet D17081- document without notice.
- Page 5 RS-485 bus high (+5 volts) and the other arm low (0 volts) using high value resistors within the third party equipment. In order to ensure that the AMG equipment detects a tri-state condition, then these resistors should have a value above 5kΩ. If the third party bias resistors are less the 750Ω...
- Page 6 Note: (A) or (B) in brackets in the above table refers to RS-485 / RS-422 data specification. Alarm Channel Configuration The AMG5614 provides one bi-directional alarm output / contact closure input. The alarm input is typically connected to a contact closure switch. An ALARM IN+ input incorporates a 330R pull-up resistor to the internal +3V3 supply.
- Page 7 ALARM OUT........Green Alarm ON / Contacts closed. Alarm OFF / Contacts open. AMG Systems Ltd. reserves the right to make changes to this Page 7 of 8 AMG5614 Instruction Sheet D17081- document without notice. The information herein is believed to 03.doc...
- Page 8 Weight..........600grams Mounting Details The AMG unit is supplied with a clip-on mounting bracket which should be attached to a panel or wall using 2 off 4.0mm screws, see diagram on page 1 for dimensions. The unit is clipped into the mounting bracket, and is then held firmly in position.
Need help?
Do you have a question about the AMG5614 and is the answer not in the manual?
Questions and answers