Epson Stylus Color Stylus Color IIs User Manual page 49

Load/Eject
Pause
Button combinations and power-on functions
The button combinations below let you perform additional
functions to control your printer.
Alt +
POWER
switch
Load/Eject +
POWER
switch
Alt + Pause
Pause +
POWER
switch
Loads or ejects a sheet of paper. The printer
normally loads and ejects paper automatically.
Stops printing temporarily. Press it again to resume
printing. To reset the printer, hold down this button
for about five seconds until all the lights turn on.
This clears the printer's buffer and restores the
factory default settings.
Prints a demonstration page of the printer's fonts
and colors. (Paper must be loaded in the printer.)
Hold down Alt until the printer feeds a page. To exit
demonstration mode, wait until the Pause light
comes on; then turn off the printer.
Checks the paper length and performs a printer self
test at 360 dpi. Hold down Load/Eject until the
printer feeds a page. To stop the self test, press the
Pause button and then turn off the printer. See
"Testing the Printer" in the Setup Guide for more
information.
Starts the print head cleaning cycle; see "Cleaning
the Print Head" in Chapter 3.
Enters the printer's Default setting mode and prints
an instruction page; see "Using the Default Setting
Mode" on page 2-23 for more information. Hold
down Pause until the printer feeds a page. To exit
the Default setting mode, press the Pause button
and turn off the printer.
Controlling the Printer
2-21