Servicing; Faqs And Troubleshooting - BMPRO Trek3 Owner's Manual

SERVICING

Do not attempt to service the Trek3 yourself, OR dismantle, modify or repair
the Trek3 yourself; this will void your warranty. If your Trek3 requires servicing,
please consult your BMPRO dealer or visit teambmpro.com for assistance.

FAQS AND TROUBLESHOOTING

Need more help troubleshooting your Trek3?
Contact our customer service team online at teambmpro.com/technical-
support
Why has the Trek3 screen turned off?
The Trek3 receives power to run the monitor from the BatteryPlus35. If the
BatteryPlus35 shuts power to the monitor, the Trek3 screen will turn off. The
BatteryPlus35 will shut power to the Trek3 if:
1.
The load isolation switch connected to the BatteryPlus35 has been
activated. This turns off power to the data cable connecting the Trek3 and
BatteryPlus35.
Check that the switch has not been activated.
2.
The BatteryPlus35 has entered Storage Mode and to conserve remaining
battery voltage will disable power to the Trek3.
To re-power the Trek3, plug the BatteryPlus35 to a power source and begin
battery charging. When the battery is sufficiently charged, the BatteryPlus35
will enable power to the Trek3.
Why are the battery volts and amp flashing on the Trek3?
Battery volts and amps will flash on the Trek3 if a BC300 + CommLink external
shunt has been installed and communication with the shunt has been lost.
Use the advanced menu function EShunt to clear the external shunt from
memory and re-establish communication with the BC300 + CommLink. See the
Appendices for more details.
I have water tanks, but they are not showing up on my Trek3?
If your Trek3 is connected to the OdysseyLink103, then the water tanks also need
to be connected to the OdysseyLink103 for them to show up.
21