BMPRO Trek3 Owner's Manual page 12

WATER PUMP BUTTON
o
To turn the water pumps connected to the BatteryPlus35 on and off. When the
BatteryPlus35 and Trek3 are first powered on, both pumps will be turned on as
well.
To turn pump 1 on/off, press the Water Pump button once.
To turn pump 2 on/off, press and hold the Water Pump button until the desired
change is seen.
In Set-Up mode, the Water Pump button acts as the DOWN-scroll arrow
function.
TIME REMAINING
a
Indicates the estimate time remaining until the battery is completely discharged.
Time remaining less than 180 minutes will be displayed in MINS. Time remaining
greater than 180 minutes will be displayed in HRS.
INPUT AMPS
s
Displays the current drawn by the BatteryPlus35 from its auxiliary and solar
inputs to power loads and charge the caravan battery.
If either of the inputs are unavailable to the BatteryPlus35, the Trek3 will display
"--.-". If either of the inputs are available to the BatteryPlus35 but not in use, the
Trek3 will display "00.0".
WATER PUMP STATUS
d
Indicates if the pumps connected to the BatteryPlus35 are turned ON or OFF.
TANK LEVEL INDICATORS
f
Monitor water tank levels of up to 4 water tanks.
By default, tanks 1 and 2 are set-up to monitor clean water tanks and tanks 3 and
4 to monitor dirty water tanks. Tank properties are configurable in Set-Up mode.
The tank level indicator will flash when the monitored tank is empty (clean
water) or full (dirty water). If a tank is not monitored, the indicator will be blank.
12