Using Your Trek3 - BMPRO Trek3 Owner's Manual

USING YOUR TREK3

The Trek3 does not have an ON/OFF button. The Trek3 receives power directly
from the BatteryPlus35 through the connected data cable. The Trek3 will
automatically turn off if it is not receiving power from the BatteryPlus35.
Upon start-up, the Trek3 will display on its Home screen, until
CAN WAIT
communication between the Trek3 and BatteryPlus35 is established.
Once communication is established, the Trek3 will display the relevant battery
and system information on its screen.
If the Trek3 cannot establish communication to the BatteryPlus35, the Trek3 will
display
CAN ERR To.
If this error occurs, check the data cable between the Trek3 and BatteryPlus35.
Figure 4: The Trek3 start-up screen
14