Advertisement
Step 1: (Vehicle Prep)
1.1 Park vehicle in a location accessible by an
overhead hoist.
1.2 Disconnect the negative battery terminal.
1.3 Remove the bolt from the battery clamp and
replace with a longer one from the supplied
hardware kit and re-use the nut, but do not re-
connect the battery.
Hardware Used
5/16x1-1/4 Square Head Bolt
1.4 Remove the plastic cover around both the left and
right control sticks. (Note: the nut on the lower
screw can be loosened slightly and the panel can
then be removed. It does not need to be fully
removed from the screw.)
1.5 Install the supplied bulb rubber to the bottom
flange of the covers. The rubber should be joined
where shown.
1.6 Re-install only the left plastic cover ensuring that
the bulb on the rubber is not causing interference
with the controls or switch. The right cover will be
re-installed in a later step.
1.7 Disconnect the wires from the stud on the starter
as well as the wire plugged into the connector on
the starter.
1.8 Remove and discard three bolts from the left side
of the engine as shown.
CAB INSTALLATION
Qty
1
Fig. 1.3 (Replace Negative Battery Bolt)
Loosen
Fig. 1.4 (Remove Covers)
Fig. 1.5 (Install Rubber (Left shown))
Remove
Disconnect
Fig. 1.7 (Remove Components)
4 of 30
Replace
Remove
Seam
Remove
Advertisement
