Advertisement
BELT ADJUSTMENT SEQUENCE
Follow this sequence to adjust or replace the OEM V-belt.
Note: The compressor belt must be re-tensioned if the OEM belt requires any adjustment.
Note: It is critical that the following steps are completed in order and followed closely. Failure to do so
may result in vehicle or component damage.
1.
Remove the shroud covering the A/C compressor
2.
Loosen the pivot bolts on the A/C compressor and remove the A/C compressor v-belt.
3.
Loosen the bolt on the lower dynamo ear 1/2 turn.
4.
Loosen the nut on the upper dynamo ear 1/2 turn.
5.
Rotate the OEM dynamo to tighten the belt and re-tighten the upper nut on the OEM dynamo. Note: Hold bolt head while
tightening.
6.
Tighten the lower pivot bolt on the OEM dynamo
7.
Re-install the A/C compressor v-belt and tension
8.
Re-install the shroud over the A/C compressor
Loosen
Nut 1/2
Turn
Loosen
Bolt 1/2
Turn
(Loosen Hardware)
Tighten
Nut
Tighten
Bolt
(Tension Belt, Tighten Hardware)
23 of 30
Hold Bolt
Head
Advertisement
