Advertisement
7.7 If installing the optional seal kit, do so at this time.
Otherwise, re-install the plastic cover (removed in
step 1.4) over the right hand control stick.
7.8 Route the remaining section of the harness with
the white connector on the end forward from the
battery area over the ROPS and up under the
seat. The harness should run across the top of
the transmission along the existing OEM harness
and end on the left side of the vehicle.
Note: Wires must be routed above the ROPS, but
below the flat area that the hood seals on when it
is closed.
7.9 Connect the white connector on the harness to the
mating connector on the secondary regulator.
7.10 Cut the blue tape on the OEM vehicle wire
harness under the seat to expose a male and
female bullet terminal. Connect the male bullet
terminal at the end of the yellow wire on the A/C
wire harness to the female bullet terminal on the
OEM harness.
CAB INSTALLATION
Fig. 7.7 (Re-Install Cover)
Fig. 7.8 (Route Wiring)
Fig. 7.9 (Connect Regulator)
Signal
Wire
Fig. 7.10 (Locate OEM Signal Wire)
16 of 30
Advertisement
