Advertisement
7.3 Install the ring terminals on the red wires onto the
stud on the positive battery clamp (outboard of the
existing battery clamp nut) and secure with the
following hardware.
Hardware Used
M6x1.0 Nut
7.4 Locate the portion of the wire harness with two
ring terminals crimped on the ends of black and
gray wires. Route the ring terminals forward over
the ROPS tube in front of the battery next to the
existing wiring and up along the right side of the
vehicle to right hand control.
Note: Wires must be routed above the ROPS, but
below the flat area that the hood seals on when it
is closed.
Avoid any moving parts.
7.5 Route the wires up behind the right control stick
and connect to the supplied switch as shown. The
gray wire should go to the center screw (NO, #3)
and the black wire should be connected to the
COM, #1 screw.
It is recommended to do the assembly over the
floor of the tractor to prevent losing any screws.
7.6 Remove the bolt shown in figure 7.6 and re-install
with the switch bracket so that the spring loaded
switch rod will be contacted by the throttle control
lever. Adjust the bracket and switch so that when
the throttle control lever is beyond 3/4 throttle the
switch is engaged. The switch can be rotated on
the bracket and the bracket can also be rotated
where it mounts to the vehicle.
CAB INSTALLATION
Qty
1
M6 Nut
Fig. 7.3 (Attach Red Wires to Battery)
Fig. 7.4 (Route Harness to Right Control Sick)
Take Image During Pilot Install
Fig. 7.5 (Connect Wires to Switch)
Fig. 7.6 (Install Switch Bracket)
15 of 30
Bolt
Advertisement
