Advertisement
Step 8: (Functionality Testing)
8.1 Ensure that all wires and hoses are securely
fastened with cable ties to prevent any rubbing or
chaffing on sharp or hot objects.
8.2 Turn the vehicle on and check to make sure that
belts and components are not vibrating
excessively.
8.3 Bring engine to full throttle, turn on A/C blower,
and move thermostat to cold.
8.4 Check to make sure A/C is blowing cold air.
8.5 Turn engine off and allow to cool.
Step 9: (Shroud Installation)
9.1 Remove the two OEM bolts shown in Figure 9.1,
install the rear shroud bracket, and re-install the
bolts.
9.2 Install the front shroud bracket oriented as shown
so that the bolts for the shroud can be installed
from the front. Secure to the pre-existing hole in
the vehicle frame.
Hardware Used
M6x1.0x20mm Flange Bolt
M6x1.0 Nylock Nut
9.3 Assemble the front shroud panel to the front side
of the bracket installed in step 9.2. Leave bolts
finger tight.
Hardware Used
1/4-20x3/4" Flange Bolts
CAB INSTALLATION
Qty
1
1
Qty
2
Remove
Bolts
Fig. 9.1 (Install Rear Shroud Bracket)
M6 Bolt
Fig. 9.2 (Install Front Shroud Bracket)
Front
Shroud
Fig. 9.3 (Install Front Shroud Panel)
18 of 30
Advertisement
