Configuring The Print Server - Epson Stylus C82WN Setup And Installation Manual

9. Continue with the following instructions to configure the print server.

Configuring the Print Server

After your print server is set up and plugged in, you're ready to configure it for your
Macintosh.
1. On the Wireless Server Search screen,
click .
START
WP-Admin picks up the signal from the print server and displays information like
the following:
This information
appears when the
server is found
Note: If WP-Admin fails to pick up a signal from the print server, try holding down
the print server's test button for five seconds to reset it. The lights go out, then
both the green and yellow lights on the print server come on briefly. The yellow
light remains on when your network has a connection to the print server.
If it still fails to pick up a signal, check the solutions beginning on page 44.
If WP-Admin picks up a signal from more than one print server, select the
connection that matches the MAC address on the back of your print server.
2. Check the signal strength to make sure you have a strong link to the print server.
3. When you have a link, click
You see the following:
.
CONFIGURE
Configuring Wireless Printing for Macintosh
This number
indicates the
signal strength
Click OK
39