Epson Stylus C82WN Setup And Installation Manual page 49

Make sure the wireless mode for your computer is set to Infrastructure if you are
connecting through an access point, or 802.11b Ad Hoc if you are connecting
without an access point. (Your wireless adapter may use different terms. Check
the documentation for your adapter.) Never select a pseudo ad hoc or proprietary
ad hoc mode.
If you are using WEP encryption on your wireless network, disable it on your
computer before you configure the print server. Then enable WEP on the print
server (see page 22). When you're done configuring the print server, enable WEP
on your computer again.
Note: If your access point only allows WEP-enabled clients to connect to it, you
may have to set your computer's wireless mode to 802.11b Ad Hoc (or your
adapter's wireless ad hoc mode) before you configure the print server. If your
computer's wireless mode was originally set to Infrastructure, you can set it back
to Infrastructure when you're done.
You see the message "Wireless Communication Failed" when you click
CONFIGURE on the Wireless Server Search window.
Click to close the message, then click
OK
Server Search window. (If WP-Admin is picking up a signal from more than one
print server, select the correct print server first.)
If you continue to see this message, move the print server closer to your computer
and access point, if you have one. Also, move the print server away from large
metal objects and other devices that interfere with radio signals, such as cordless
phones and microwave ovens.
Your network could be malfunctioning. If you have an access point, make sure it
is turned on and configured correctly. Try resetting the access point. See the
instructions that came with your access point for more information.
again on the Wireless
CONFIGURE
Solving Wireless Printing Problems
45