Draining The Appliance; Draining The Appliance After A Long Period Of Inactivity (More Than 3 Months); Cleaning The Casing Of The Device; Installation (Only For Approved Contractors) - Bosch TRONIC 1000 T Installation And Operating Instructions Manual

Installation (only for approved contractors)

WARNING
Risk of scalding!
High hot water temperature.
▶ Before opening the pressure relief valve, open the hot water
tap and check the appliance's water temperature.
▶ Wait until the water temperature has dropped enough to
prevent scalding and other damages.
Before activating the pressure relief valve,
▶ Disconnect the appliance from the electricity.
▶ Close the water shut-off valve and open a hot water tap.
▶ Open the pressure relief valve.
Fig. 8 Opening the pressure relief valve
▶ Check if the pressure relief valve is working properly.
▶ Open the water shut-off valve.
▶ Connect the appliance to the electricity.
4.6

Draining the appliance

CAUTION
Risk of damage to property!
Whenever there is risk of freezing, the water inside of the
appliance may damage the components.
▶ Place a container below the appliance to collect all of the
water that comes out of the appliance.
▶ Drain the appliance.
In the case of risk of freezing, please act as follows:
▶ Close the water shut-off valve ( Fig. 13, [5]).
▶ Open a hot water tap.
▶ Open the pressure relief valve.
▶ Wait until the appliance has drained fully.
158
0010031646
4.7 Draining the appliance after a long period of
inactivity (more than 3 months)
The water inside of the appliance should be replaced in the case
of lack of use for a long period of time (more than 3 months).
▶ Disconnect the appliance from the electricity.
▶ Empty the appliance completely.
▶ Fill the appliance until the water is drained from the hot
water taps.
▶ Close the hot water taps.
▶ Connect the appliance to the electricity.
4.8

Cleaning the casing of the device

▶ Only clean the casing of the device with a damp cloth and a
little cleaning agent.
Never use aggressive or caustic cleaning agents.
5 Installation (only for approved
contractors)
5.1

Important information

The installation, electrical connection and the initial
commissioning are operations must be carried out by
specialised and qualified persons only.
In order to ensure the correct installation and operation of the
device, please observe all regulations, technical guidelines and
applicable national and regional directives.
Tronic 1000 T | Tronic 2000 T – 6721831855 (2021/03)