Perkins 1206E-E70TTA Operation And Maintenance Manual page 54

54
Operation Section
Configuration Parameters
Configuration Parameters
The engine electronic control module (ECM) has two
types of configuration parameters. The system
configuration parameters and the customer specified
parameters.
The electronic service tool is required in order to alter
the configuration parameters.
System Configuration Parameters
System configuration parameters affect the
emissions of the engine or the power of the engine.
System configuration parameters are programmed at
the factory. Normally, system configuration
parameters would never require changing through
the life of the engine. System configuration
parameters must be reprogrammed if an ECM is
replaced. System configuration parameters do not
require reprogrammed if the ECM software is
changed. Factory passwords are required to change
these parameters.
Table 4
Configuration Parameters
Engine Serial Number
Delayed Engine Shutdown
Factory Installed Aftertreatment #1 Identification Number
DPF #1 Soot Loading Sensing System Configuration Code
Limp Home Engine Speed Ramp Rate
System Operating Voltage Configuration
Rating Number
CAN Communication Protocol Write Security
Customer Specified Parameters
Customer specified parameters allow the engine to
be configured to the exact needs of the application.
The electronic service tool is required in order to alter
the customer configuration parameters.
Customer parameters may be changed repeatedly as
operational requirements change.
Table 5
Specified Parameters
i03905586
System Configuration Parameters
Customer Specified Parameters
SEBU8601-04
Record
Record
(continued)