Perkins 1206E-E70TTA Operation And Maintenance Manual page 111

SEBU8601-04
Illustration 70
Typical example
(A) Alignment postion
(B) Alignment postion
3. Note the orientation of the filter element. Remove
the filter element (4) from the bottom cap (2).
Remove the seal (5).
Note: The bottom cap has a section that allows
access to remove the seal.
4. Install a new seal (5). Install a new filter element
into the bottom cap (2).
5. Align position (A) on the top cap to position (B) on
the filter element. Refer to illustration 70 .
6. Install the assembly of the filter element and the
bottom cap (2). Rotate the bottom cap by hand
clockwise until the bottom cap locks into the
locked position on the breather body. Ensure that
the alignment marks (X and Y) are correctly
aligned. Refer to illustration 69 .
Engine Crankcase Breather Element - Replace
7. Install tube connection (1). Ensure that the
retaining clips on the tube connection are correctly
engaged. Remove the container.
Check the System
Illustration 71
g03090968
Typical example
Inspect the breather tube (1) for damage. Ensure that
the outlet (2) is clean and free from any obstructions.
Ice can cause obstructions in adverse weather
conditions.
Engine Crankcase Breather
Element - Replace
(Type 2)
Hot oil and hot components can cause personal
injury. Do not allow hot oil or hot components to
contact the skin.
Ensure that the engine is stopped before any servic-
ing or repair is performed.
The crankcase breather is a very important
component in order to keep your engine emissions
compliant.
Maintenance Section
g02346500
i08421031
NOTICE
111