Perkins 1206E-E70TTA Operation And Maintenance Manual page 119

SEBU8601-04
6. Tighten the vent screw (1) securely . Remove the
wiring harness from connection (4).
7. Remove the filter bowl (6). Rotate the filter
assembly counterclockwise in order to remove the
filter assembly. Use a suitable tool in order to
remove the filter assembly.
Illustration 82
Typical example
Fuel System Primary Filter (Water Separator) Element - Replace
8. Rotate the filter element counterclockwise and
remove the filter element (5). Clean the filter bowl.
Install the Element
Illustration 83
Typical example
g02148402
1. Locate the thread in the filter element (8) onto the
threads (9). Spin on the element. Do not tighten.
2. Lubricate the O ring seal (7) with clean engine oil.
Do NOT fill the bowl with fuel before the assembly
is installed.
3. Do not use a tool in order to install the filter
assembly. Tighten the filter bowl (6) by hand.
Install the filter bowl (6) and align with your
temporary marks (A).
4. Tighten the valve (2) securely. Remove the
container and dispose of the fuel in a safe place.
119
Maintenance Section
g02148441