Space-Ray LTU 160/100-N7 Installation And Operation Instructions Manual page 36

Infrared radiant tube heater
Table of Contents

Advertisement

US ONLY:
A gas connector certified for use on a tubular type infrared heater per the standard for Connectors
for Gas Appliances, ANSI Z21.24/CSA 6.10 is supplied for installation in US only. The gas connector is 36" long
and 1/2" nominal ID, and must be installed as shown above, in one plane, and without sharp bends, kinks or
twists. Note: The gas connector supplied with LTS/LTU 225 and 250 is 36" long and 3/4" nominal ID.
CANADA ONLY:
A Type I hose connector should be used that is certified as being in compliance with the
Standard for Elastomeric Composite Hose and Hose Couplings for Conducting Propane and Natural Gas
(CAN/CGA 8.1) and is of length of 36+/- 6 in (90+/- 15 cm). The gas connector must be installed as shown
above, in one plane, and without sharp bends, kinks or twists.
Form #43155010
Dec 2017
US ONLY: Connector MUST be installed in "" configuration. Use only
the 36" long connector that was furnished with this heater.
-35-

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents