Space-Ray LTU 160/100-N7 Installation And Operation Instructions Manual page 28

6. Assemble reflectors onto the body sections. Reflectors should overlap 1" to 2" and must be secured with
each other by sliding speed clips on the reflector edges. One speed clip is required for each side of the
reflectors.
7. Fasten reflectors to all of the tube support/hanger brackets as marked per (DETAIL–A) with (2) #10 sheet
metal screws. Note: The reflector overlap at all joints must be able to slide for expansion of the heater.
8. Mount the sliding reflector clamps (#42769010) per Reflector Clamp Installation (DETAIL-B) on all tube
support/hanger brackets. Make sure the reflectors can slide under the clamp during heater operation.
Form #43155010
Dec 2017
The reflector clamps MUST be installed per reflector clamp
installation detail which allows the reflector to slide under the
clamp during heater operation.
-27-