Space-Ray LTU 160/100-N7 Installation And Operation Instructions Manual page 34

2. Pull the motor and blower wheel assembly with the motor plate slightly from the end of the housing studs.
Use care not to damage the motor leads.
3. Rotate the junction box assembly to the upright position using the multi-hole mounting bracket.
4. Replace the motor and blower assembly. Tighten the locknuts.
5. Horizontal and 45º draft inducer positions can allow the plastic vacuum air tube to sag. The air tube should
be shortened to prevent a downward sag that could allow condensation build-up in the tube.
Form #43155010
Dec 2017
Failure to install the control box in an upright position and lights
facing the floor will void the manufacturer's warranty.
-33-