Bernini Piccolo Fountain Tower Owner's Manual

*PLEASE READ THESE INSTRUCTIONS COMPLETELY BEFORE ATTEMPTING TO ASSEMBLE YOUR NEW FOUNTAIN
CONTENTS:
Alignment
Notch In
Base
Water
Fountain
Tube
Base
Please note, images of parts
Battery Compartment
are not to scale with one another.
STEP
2.

Assembly

Battery Compartment Battery Compartment
Retaining Screws X2 Retaining Screws X2
Figure 1a
Figure 1b
Need Help?
Call us for assistance at:
+1 (619) 449-2392
or you can email us at:
customercare@berninifountains.com
For video tutorials visit:
berninifountains.com/support
Our Customer Care Department is available:
Monday - Friday 8:30am to 4:00pm PST
11:30am - 7:00pm EST
1. Take the Fountain Top/Battery Compartment and Water Pump, connect one side of the Water Tube to the Water Pump and the other end to the bottom side of the
Battery Compartment (A & B of Figure 4).
2. Find a suitable bowl and place it on a flat, level surface and place the Fountain Base, without the Fountain Top with Battery Compartment and Water Pump, into
the center of the bowl.
3. Lower the Fountain Top with Battery Compartment and Water Pump into the Fountain Base. There are two locating dowels and two alignment notches that help
you align the Fountain Top to the Fountain Base. Fit these into place and press to Fountain Top and Base together to secure(Figure 6).
4. Fill bowl with water, water level should cover the Water Pump (Diagram 1a).
STEP
3.

OPERATING YOUR FOUNTAIN TOWER:

Turn On Fountain: When the Fountain is off, press the button to turn on (Figure 7a & b). The fountain will run for one hour and automatically turn off.
Stop Fountain: To stop the Fountain press the button to turn off.
DANCING WATER ATTACHMENT (OPTIONAL): When Fountain is not running, attach the Dancing Water Attachment and attach to the outlet in the middle of the
Fountain Tower (Figure 8a, 8b and 8c). To prevent overspray, use a larger bowl.
Button Button
Figure 7a
Diagram 1a:
Start/Stop
Dancing Button
Water
Battery
Attachment Compartment
Screws x2
Max Water Level
(Upper
Decorative
Ring)
Fountain Top With
& Water Pump
Locating Locating
Dowel Dowel
Alignment Alignment Alignment
Figure 2a
Notch in Notch in Notch in
Battery Cover Battery Cover
Fountain Battery Battery
Housing Housing Top
Retaining Nut O-Ring
Battery Cover Battery Cover
O-Ring O-Ring
Figure 3a
Figure 7b
Piccolo Fountain Tower
Locating Dowls
Alignment
Notch
Recommended minimum bowl size
is approximately 6 inches
Alignment Alignment
Notch in Notch in
Fountain Battery
Housing Top
Figure 2b
Battery Cover Battery Cover
Figure 2b
Retaining Nut O-Ring
Figure 3b
Dancing Water Attachment
Note: Minimum bowl size is 6 in. It is
recommended that the Dancing
Water Attachment be used outdoors.
To prevent over spray use a larger bowl.
Figure 8a
O W N E R S M A N U A L
STEP

INSTALLING BATTERIES:

Dancing
1. Lift Fountain Top with Battery Compartment & Water
Water
Pump out of the Fountain Base (Figure 5). Disconnect
Attachments
the Water Tube from the Battery Compartment.
Fountain
2. Unscrew (counter clockwise) the Battery Compartment
Top
Screws and open cover (Figure 1a, 1b).
3. Orient the Battery Compartment with locating dowel on top.
(See Arrow Figure 2a& 2b).
Battery
Compartment
4. Insert 2-1.5v AA Batteries with the (+) side facing up in
(4 1.5v AA
Battery Compartment and 2 AA Batteries with the (-) facing up in
Batteries
Not Included) Battery Compartment (Figure 2a).
5. Reinstall the Fountain Top by aligning the locating dowel in
Fountain
the Battery Compartment and Fountain Top. Set the Battery
Base
Cover down onto the Battery Compartment ensuring the dowel
sets into the alignment hole. Tighten the Battery Cover Screw by
Water Pump
Tube turning clockwise. NOTE: You may need to apply pressure to
the Battery Compartment Screws while tightening for the
Bowl
threads to catch.
(Not Included)

CHANGING BATTERIES:

1. Remove any Dancing Water Attachment, lift Battery
Minimum
Compartment and Water Pump out of the Fountain (Figure 5),
Water
ensure Battery Compartment and Water Pump are completely
Level
dry before opening Battery Compartment. It is important that
Water
no water enters the Battery Compartment.
Pump
2. See Installing Batteries Section above on how to reinstall
batteries and reassemble.
3. Set the Battery Compartment and Water Pump back into the
Fountain (Figure 6).
A
B
Figure 4
Figure 5
Figure 8b
TM
Figure 6
Figure 8c