Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Bernini RF-1
Summary of Contents for Bernini RF-1
- Page 1 Bluetooth Music Fountain RF-1 Fountain Model Number:RF-1 Owner’s Manual...
-
Page 2: Table Of Contents
Contents Step1: Battery and Speaker Assembly Step 2: Pump and Battery Installation Step 3: Setting Up Your Fountain Fill Your Fountain 7 Operating Your Fountain Troubleshooting and Maintenance Recharging Th e Battery Cleaning the Water Pump’s Parts 9 Water Pump Air Filters Water Pump Impeller Priming the Water Pump 10... - Page 3 IMPORTANT BATTERY SAFETY INSTRUCTIONS, READ FIRST DANGER: Do not store battery in an airtight container as it may cause an explosion. PROPOSITION 65 WARNING: Battery posts, terminals and related accessories contain lead and lead compounds, chemicals known to the State of California to cause cancer and reproductive harm.
- Page 4 Parts for Your Bernini Fountain Rechargeable Water Pump Battery Fountain Body Speaker Access Panel Assembly Cover...
-
Page 5: Step1: Battery And Speaker Assembly
Step 1: Battery and Speaker Assembly Parts you will need for this section Rechargeable Battery Speaker Assembly... - Page 6 - next step). battery. At this point, your speaker and battery assembly should look like the image above. Go to the next page for the next step to set up your new Bernini Fountain.
-
Page 7: Step 2: Pump And Battery Installation
Step 2: Pump and Battery Installation Parts you will need for this section Water Pump Fountain Body Access Panel Cover Battery & Speaker... - Page 8 Securely attach plastic tube to nip- Insert battery assembly, speaker fi rst, ple on the back of the water pump. into the left compartment. Properly Place water pump in the reservoir on installed, the battery will lay fl at on the the right.
- Page 9 Slide into place to close. At this point, your fountain should look like the image on the left (rear view). Go to the next page for the next step to set up your new Bernini Fountain.
-
Page 10: Step 3: Setting Up Your Fountain
Step 3: Setting Up Your Fountain Parts you will need for this section & Water to fi ll your fountain Fountain assembled... -
Page 11: Fill Your Fountain
Selector/Volume) 2. Long Press - turns up volume. You can now try your Bernini fountain to see if everything is working correctly! Turn your fountain on and if you see water fl owing, you are ready to enjoy your new Bernini Fountain. If water is not fl owing, try priming the water... -
Page 12: Recharging The Battery
DO NOT CHARGE ON COUNTER TOPS, CARPETS OR OTHER FINISHED SURFACES. IT IS RECOMMENDED THAT THE BATTERY BE PLACED ON A CONCRETE SURFACE WHILE CHARGING. The yellow receptacle is not needed for the initial setup of your Bernini Fountain. This is used for the op- tional solar panel. -
Page 13: Cleaning The Water Pump's Parts
The impeller inside of the water pump is what pushes water up through your fountain, allowing you to enjoy the soothing sounds and wonderful sights of your Bernini Foun- tain. After long periods of usage, this part will need to be cleaned to make sure your fountain runs optimally. -
Page 14: Priming The Water Pump
Priming the Water Pump If you fi nd the water pump is running, but water is not fl owing from your fountain, you can try priming the water pump: Detach the water pump from the feeder tube inside the fountain. When removing the water pump, use caution when pulling the pump from the feeder tube. - Page 15 FCC STATEMENT This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference. (2) This device must accept any interference received, including interference that may cause undesired operation.
Need help?
Do you have a question about the RF-1 and is the answer not in the manual?
Questions and answers