Epson FX-870 User Manual page 120

Regular gays occur in the printout.
l
1 inch skip-over-perforation may be on. Turn this function off
in the default-setting mode.
Skip-over-perforation is set, but the perforation does not fall in the
l
center of the skip.
Adjust the top-of-form position. See page 2-19.
Make sure the default page length setting matches your
required paper length. See page 3-5.
If your application program is setting the top and bottom
margins, set the skip-over-perforation off in the default-setting
mode.
Printing starts too low on the page, or the bottom part
l
printed at the top of the next page.
Be sure to choose the correct printer from your application
program's menu. See page 1-15 .
Use your application software to reduce or eliminate the top
margin and to reduce the page length.
If possible, specify single-sheet paper with your application
software.
If the printer still does not print correctly, try the self test described
in Chapter 1. If the self test works properly, the printer is all right
and the problem probably lies in the computer, the software, or the
cable. If the self test does not work, contact your dealer or a qualified
service person.
one page is
of
Troubleshooting 6-7
Printing