Status And Error Messages; The Messages - Epson EPI-4000 User Manual

Status and Error Messages

The control panel gives you two types of information: status
messages and error messages. Status messages appear on the
display during the normal operation of your printer. They indicate
the printer's current status. When an error occurs, an error message
appears to tell you what is wrong.
This section lists and describes in alphabetical order possible status
and error messages and their meanings. You can correct most
problems causing the error messages easily by following the
suggestions provided below.
Chapter references are included where necessary to help you find
more information about each message.

The Messages

The printer is warming up. Wait until the message clears to print
data.
When you use a software command to set the number of lines per
page to a value larger than 99, you can use SelecType to display the
parameter. The printer displays the value as
to change the lines per page setting.
bF Insufficient
The printer does not have enough memory available to store all the
downloadable fonts or macros that were sent to it. Reduce the
number of fonts or macros you are using. You can press ON LINE to
print the current page in the printer's memory, but your printout
be
may incomplete. If this message appears often, install an optional
memory board as described in Chapter 4.
Troubleshooting
6-2
memory
or See Chapter 2