Supermicro SuperServer 8049U-E1CR4T User Manual page 72

SuperServer 8049U-E1CR4T User's Manual
Power-Failure Throttling Enable/Disable
The Power-Failure Throttling jumper is located at J17. Close pins 2-3 to enable the power
throttling feature. The default setting is pins 1-2 for normal (disabled) operation.
Management Engine (ME) Recovery
Use jumper JPME1 to select ME Firmware Recovery mode, which will limit resource
allocation for essential system operation only in order to maintain normal power operation
and management. In the single operation mode, online upgrade will be available via Recovery
mode.
Watch Dog
JWD1 controls the Watch Dog function. Watch Dog is a monitor that can reboot the system
when a software application hangs. Jumping pins 1-2 will cause Watch Dog to reset the
system if an application hangs. Jumping pins 2-3 will generate a non-maskable interrupt
signal for the application that hangs. Watch Dog must also be enabled in BIOS. The default
setting is Reset.
Note: When Watch Dog is enabled, the user needs to write their own application software
to disable it.
VGA Enable/Disable
JPG1 allows you to enable or disable the VGA port, which is supported by the onboard BMC
controller. The default setting is Enabled.
Power-Failure Throttling
Jumper Settings
Jumper Setting Definition
Pins 1-2 Normal (Disabled)
Pins 2-3 Enabled
Manufacturer Mode
Jumper Settings
Jumper Setting Definition
Pins 1-2 Normal
Pins 2-3 ME Recovery
Watch Dog
Jumper Settings
Jumper Setting Definition
Pins 1-2 Reset
Pins 2-3 NMI
Open Disabled
VGA Enable/Disable
Jumper Settings
Jumper Setting Definition
Pins 1-2 Enabled
Pins 2-3 Disabled
72