Installing Expansion Cards
1. Power down the system as described in Section 3.1 and remove the cover.
2. Remove the chassis bracket across the top of the chassis.
Bracket
3. Unlatch the required riser card housings. (Housings are pictured in drawings Figures
18–22.) On the rear of the chassis, each bracket is secured by a small black plastic flip-
switch with an arrow on it. Flip open the appropriate switch to release the bracket.
Chapter 3: Maintenance and Component Installation
Figure 3-16. Removing Bracket
Ultra Riser Cage Release Tab
Figure 3-17. Riser Cage Release Tabs
57
WIO Riser Cage Release Tab