Supermicro SuperServer 8049U-E1CR4T User Manual page 153

F.2 Enabling NVMe RAID
RAID for NVMe SSDs must be enabled through the UEFI BIOS.
1. Install the patch as described in the Restrictions and Requirements section on a
previous page.
2. Reboot the server.
3. Press [DEL] key to enter BIOS.
4. Switch to Advanced > Chipset Configuration > North Bridge > IIO Configuration >
Intel® VMD Technology > Intel VMD for Volume Management Device on CPU 4.
5. Enable the VMD according to the following rules.
•
For M.2 NVMe or NVMe AIC, enable the VMD according to which AOC card/slot it used.
•
For U.2 NVMe, enable all the sub-items for CPU4 under VMD Config for PStack0 and
VMD Config for PStack1.
Example for 8049U-E1CR4T populated with eight U.2 NVMe drives:
CPU4 Configuration
Figure F-2. BIOS VMD Setting Example
153
Appendix F: CPU-Based RAID for NVMe