Table of Contents
Advertisement
A+ Server AS -4023S-TRT User's Manual
Rotating the Mobile Rack
If the system is to be used in a rack configuration, you must rotate the mobile rack enclosure
module 90 degrees. This can be done before, during, or after setup. Although the drives in the
mobile rack may be hot-swapped, the system must be shut down to rotate the mobile rack.
1. Begin by removing power from the system as described in Section 3.1 and remove the
side cover as described in section 3.2.
2. Disconnect any cables from the back of the mobile rack.
3. Lift the mobile rack release levers to unlock the mobile rack (levers are located at the
top and bottom of the rear of the mobile rack).
4. Grasp the edges of the mobile rack and pull it from the chassis.
5. Turn the module 90 degrees (as illustrated).
6. Reinsert the module into the enclosure and reconnect the cables.
7. Reconnect the power cords to the power supplies and turn the system on.
Mobile Rack Enclosure
Mobile Rack
Figure 3-9. Rotating the Mobile Rack
42
Enclosure Release Lever
Advertisement
Table of Contents
