Memory Module - Epson ActionLaser 1600 Reference Manual

Note:
Hook no more than two cables into one cable clip. Never put too much
pressure on the cables.
8. Turn the printer around so that the control panel faces you. Make sure
the printer is turned off; then plug the power cord into the printer
and into an electrical outlet.
Before you use the optional interface, you may need to change the printer
emulation setting using SelecType. See Chapter 5 for more information
about changing the emulation If your optional interface is parallel and
you want to use LJ4 emulation for the new interface, you do not need to
change the setting.
You can verify whether the interface is correctly installed by printing a
status sheet, which lists the printer's current settings. See Chapter 4 for
information about printing the status sheet.

Memory Module

By installing one or two Single In-Line Memory Modules (SIMMs), you
can increase printer memory up to 64 MB. You may want to add
additional memory if you are having difficulty printing complex,
graphics-intensive pages or if you regularly use ntm-terous downloaded
fonts.
You can purchase SIMMs from various vendors. Be sure the SlMMs you
purchase meet the following requirements:
Capacity of 1,2,4,8,16, or 32 MB
Dimensions within 108 mm (4.25 inches)
with a diameter of 10 mm (.4 inches)
To install SIMMs, you must remove the controller board. Some of the
electrical components that are exposed when you remove,the controller
board may be very hot if you have recently been using the printer. Do not
touch any electrical components unless instructed to do so.
C - 1 0 Qptio?l1nsta1lation
36 mm (1.4 inches),
x