Epson ActionLaser 1600 Reference Manual page 100

Fan the stack of paper and then tap it on the edge to align it
before you load it.
Be sure that you do not load too much paper in the tray.
Be sure to adjust the paper guides so that the paper can
slide in and out freely.
Never let more than 100 sheets accumulate in the standard
facedown output tray on top of the printer.
Try turning over the stack of paper in the tray. Most paper
packages indicate which side should be face up.
Display panel stays blank when you turn printer on
Turn off the printer and check the power cable connections
between the printer and the electrical outlet; then turn the
printer back on.
If the electrical outlet is controlled by an outside source such as
a wall switch, make sure the switch is turned on or plug
another electrical device into the outlet to check whether the
outlet is operating properly.
The On Line light is on but nothing prints
Your computer may not be properly
Perform the procedure "Testing the computer-to-printer
connection" in the Read 7% First guide.
The interface cable may not be plugged in securely. Check both
ends of the cable between the printer and the computer. If you
are using a parallel interface, secure the connector using the
wire retaining clips.
6-4
to the printer.
connected