New Holland P2350 Service Manual page 12

DO NOT attempt to remove material from any part of the machine while it is being operated or components are in
motion.
Make sure all guards, shields and handrails are in good condition and properly installed before operating machine.
Never operate the machine with shields removed. Always close access doors or panels before operating the machine.
Dirty or slippery steps, ladders, walkways and platforms can cause falls. Make sure these surfaces remain clean and
clear of debris.
A person or pet within the operating area of a machine can be struck or crushed by the machine or its equipment. DO
NOT allow anyone to enter the work area.
Raised equipment and/or loads can fall unexpectedly and crush persons underneath. Never allow anyone to enter
the area underneath raised equipment during operation.
Review this manual before each season of use.
Never allow anyone unfamiliar, untrained, or complacent to operate the implement.
Use extreme care when cleaning, filling, or adjusting the implement.
DO NOT enter tank unless another person is present.
DO NOT work around rotating equipment. Loose clothing, rings, watches, etc. may get caught and cause serious
injury.
Air and air hoses
COMPRESSOR HOSES may move unexpectedly when suddenly disconnected.
USE PROPER air nozzles. Never use compressed air to clean off clothes or otherwise direct it toward yourself.
General maintenance safety
Keep area used for servicing the machine clean and dry. Clean up spilled fluids.
Service machine on a firm level surface.
Install guards and shields after servicing the machine.
Close all access doors and install all panels after servicing the machine.
Do not attempt to clean, lubricate, clear obstructions or make adjustments to the machine while it is in motion or while
the engine is running.
Always make sure working area is clear of tools, parts, other persons and pets before you start operating the machine.
Unsupported hydraulic cylinders can lose pressure and drop the equipment causing a crushing hazard. Do not leave
equipment in a raised position while parked or during service, unless securely supported.
Incorrect towing procedures can cause accidents. When towing a disabled machine follow the procedure in this man-
ual. Use only rigid tow bars.
Stop the engine, remove key and relieve the pressure before disconnecting or connecting fluid lines.
Stop the engine and remove key before disconnecting or connecting electrical connections.
Replace damage or worn tubes, hoses, electrical wiring, etc.
INTRODUCTION
47827462 28/04/2017
7