Connect To Your Computer - Epson Stylus Photo RX500 Start Here Manual

8
Install Software and

Connect to Your Computer

The software works with
OS 8.6 to 9.x and OS X 10.2 to 10.3.
Windows
1
Make sure the RX500 is not
connected to your computer,
then turn on your computer.
Note: If your RX500 is turned on
and connected, you may see
several New Hardware screens.
Click Cancel for each one and
disconnect the RX500. You can't
install your software that way.
2
Insert the Epson CD-ROM in your
CD-ROM or DVD drive.
Note: With Windows XP, if you see a
message asking what you want
Windows to do, click Cancel.
3
When you see this screen, click
Install.
If this screen doesn't open
automatically, double-click
My Computer (or click Start >
My Computer). Then double-click
the EPSON CD-ROM icon.
4
Read the license agreement and
click Agree to continue. The
computer installer copies files to
your computer.
5
When you see this screen, make
sure the RX500 is turned on, then
lift up the scanner.
6
Remove the yellow sticker and plug the square end of a USB cable into
the USB port on the RX500. Then route the cable in the slot as shown.
Caution: Make sure the USB cable fits securely into the slot. The USB
connector may snap if the cable is not routed correctly and the scanner
is closed with force.
7
Close the scanner carefully.
8
Plug the flat end of the cable into
any available USB port on your
computer. Several messages
appear on the screen. Wait for all
the screens to disappear.
Note: If the blue USB screen
doesn't disappear, make sure the
RX500 is turned on and securely
connected to your computer.
Windows ® 98, Me, 2000, and XP, and Macintosh ®
continue