Load Paper - Epson Stylus Photo RX500 Start Here Manual

6
Press down on each cartridge until it clicks into
place. Then close the ink cartridge cover.
Caution: Don't force the cartridge cover closed.
If it doesn't close easily, open it and make sure
all the ink cartridges are firmly seated.
7
Lower the scanner unit.
The RX500 begins charging the ink
delivery system.
Charging takes about 2 minutes. Initial
charge appears on the RX500 screen.
Note: Don't turn the RX500 off while you
see the Initial Charge message or you'll
waste ink.
7

Load Paper

1
Insert the paper support into
the two slots on the back of
the RX500.
2
Connect the short cable leading
from the scanner lid to the round
connector on the back of the
RX500.
Position the connector as shown
here before pushing it in. Don't
force it.
3
Open the output tray.
4
Flip the feeder guard forward.
5
Place a stack of paper in the top
of the RX500, between the edge
guides and beneath their tabs.
Then slide the left edge guide
against the paper, but not
too tightly.
6
Flip the feeder guard back over
the stack of paper.
Note: If you forget to flip the
feeder guard back, your paper
may jam.