Connect To Your Computer - Epson Stylus Photo RX600 Start Here Manual

8
Install Software and

Connect to Your Computer

The software works with Windows
OS 9 and OS X 10.2 and later.
Windows
1
Make sure the RX600 is not
connected to your computer.
Then turn on your computer.
Note: If your RX600 is turned on
and connected, you may see
several New Hardware screens.
Click Cancel on each of these
screens and disconnect the RX600.
You can't install your software
that way.
2
Insert the Epson CD-ROM in your CD-ROM
or DVD drive.
Note: If you're using Windows XP and you
see a message asking what to do with your
CD, click Cancel.
3
When you see this screen, click Install:
If this screen doesn't appear,
do the following:
Windows XP: Click Start >
My Computer. Then double-click
the EPSON CD-ROM icon.
For Windows 98/Me/2000:
Double-click My Computer.
Then double-click the EPSON
CD-ROM icon.
4
Read and agree to the license
agreement to continue.
You see this screen and the installer
begins copying several software
programs to your computer:
5
When you see this screen, connect
the USB cable extending from the
RX600 to any open USB port on your
computer. Several messages appear
on the screen. Wait for all the screens
to disappear.
Note: If the blue USB screen doesn't disappear, make sure the RX600
is turned on and securely connected to your computer. If you see a
message about a Hi-speed device plugged into a non-Hi-speed hub,
close the message screen.
6
When you see a message that you
have successfully installed the
RX600 drivers, click Next.
® 98SE, Me, 2000, and XP, and Macintosh ®
continue