Page 1
INSTALLATION GUIDE FOR T-HARNESS T1 (THAR-CHR1) AND T-HARNESS T2 (THAR-CHR2) GUIDE INSTALLATION POUR HARNAIS T1 (THAR-CHR1) ET HARNAIS T2 (THAR-CHR2) INTERFACE FOR REMOTE CAR STARTERS OR ALARM INTERFACE POUR DÉMARREURS À DISTANCE OU SYSTÈMES D’ALARME Volkswagen REQUIRED Hardware Ver: 4 FIRMWARE 2.0 (and higher - et plus) Firmware Ver: 2.0 Date: xx-xx...
Page 3
Page 3 Déterminez si le démarreur Determine if the remote- à distance ou système starter or alarm system d'alarme est compatible en supports 2-way Data-Link. Data-Link 2-voies. VEHICLE FUNCTIONALITY (IF EQUIPPED) VEHICLE CONNECTION FONCTIONS S’APPLIQUENT SI LE VÉHICULE EN EST ÉQUIPÉ FIT GUIDE YEARS | ANNÉES 04 05 06 07 08 09 10 11 12...
Page 4
Page 4 EVO-CHR T1 (THAR-CHR1) EVO-CHR T1 (THAR-CHR1) CONNECTION GO PROGRAM: 1 WITH DATA-LINK \ AVEC DATA-LINK OUTPUT | SORTIE INPUT | ENTRÉE wire-to-wire Always connect Toujours branché 1-way Only connect for 1-Way Data-Link DATA Remote Starter or Alarm PORT Démarreur ou alarme Branchez pour Data-Link 1-voie seulement n.c.
Page 5
Page 5 EVO-CHR T1 (THAR-CHR1) CONNECTION GO PROGRAM: 1 WITHOUT DATA-LINK \ SANS DATA-LINK OUTPUT | SORTIE INPUT | ENTRÉE Remote Starter or Alarm Démarreur ou alarme Trunk | Valise Yellow/Black | Jaune/Noir Purple/White | Mauve/Blanc Unlock | Déverrouille CONN. 2 E-Brake Status Frein Main Orange/Black | Org/Noir Door Status Porte...
Page 6
EVO-CHR T2 (THAR-CHR2) Page 6 CONNECTION GO PROGRAM: 1 WITH DATA-LINK \ AVEC DATA-LINK WITH DATA-LINK OUTPUT | SORTIE INPUT | ENTRÉE Dodge Dakota 2005-2006 - Dodge Durango 2004-2006 Ign.1, Ign.2, Acc.1, Acc.2, Start1 & Key Sense wires from the vehicle ignition main harness must be connected to the remote-starter.
Page 7
Page 7 EVO-CHR T2 (THAR-CHR2) CONNECTION GO PROGRAM: 1 WITHOUT DATA-LINK \ SANS DATA-LINK OUTPUT | SORTIE INPUT | ENTRÉE Dodge Dakota 2005-2006 - Dodge Durango 2004-2006 Ign.1, Ign.2, Acc.1, Acc.2, Start1 & Key Sense wires from the vehicle ignition main harness must be connected to the remote-starter.
Page 8
Page 8 EVO-CHR T2 (THAR-CHR2) CONNECTION GO PROGRAM: 2 WITH DATA-LINK \ AVEC DATA-LINK OUTPUT | SORTIE OUTPUT | SORTIE INPUT | ENTRÉE INPUT | ENTRÉE Starter (+) (+) Ignition 2 (-) While running 1-way Only connect for 1-Way Data-Link Remote Starter or Alarm Démarreur ou alarme Branchez pour Data-Link 1-voie seulement...
Page 9
Page 9 EVO-CHR T2 (THAR-CHR2) CONNECTION GO PROGRAM: 2 WITHOUT DATA-LINK \ SANS DATA-LINK OUTPUT | SORTIE OUTPUT | SORTIE INPUT | ENTRÉE INPUT | ENTRÉE Starter (+) (+) Ignition 2 (-) While running Remote Starter or Alarm Démarreur ou alarme Yellow/Black | Jaune/Noir Trunk | Valise Purple/White | Mauve/Blanc...
Page 10
Page 10 EVO-CHR T1 (THAR-CHR1) PROGRAMMING | PROGRAMMATION Vehicles with OEM alarm Véhicule avec alarme d'origine Or | Ou Purple/White Flash 1 sec. The Red Insert Insert the 4 pin Turn the Ignition to The Red LED LED is connector 2 (16 (Data-Link) the ON/RUN start to flash...
Page 11
EVO-CHR T2 (THAR-CHR2) Page 11 PROGRAMMING | PROGRAMMATION Vehicles with OEM alarm Véhicule avec alarme d'origine Or | Ou Purple/White Flash 1 sec. The Red Insert Insert the 4 pin Turn the Ignition to The Red LED LED is connector 2 (16 (Data-Link) the ON/RUN start to flash...
TECHNICAL SUPPORT / INFORMATION Neither the manufacturer or distributor of this module is responsible for damages of any kind either indirectly or directly caused by this module, except for the replacement of this module in case of manufacturing defects. This module must be installed by a qualified technician.
Need help?
Do you have a question about the EVO CHR T1 and is the answer not in the manual?
Questions and answers