Drawing 11
6.8 Electrical installation
The UV system is supplied with a permanently connected power cord with plug, this must be connected to a
wall socket with protective ground. For this, also follow the mains voltage specifications as specified in the
'Mains voltage' chapter.
●
VGE International B.V.
Ekkersrijt 4304
Ensure that the UV lamp is always in the closed position (arrow on the lamp base
matches the position of the closed lock on the lamp socket) before switching on the
UV lamp.
Making changes to the UV system is not permitted.
For the installation of the UV system and therefore also the control system, follow
the guidelines described in the chapter 'Environmental conditions'.
Also follow the instruction as described in the 'Safety instructions' chapter to work
safely.
Ensure that the grounding cable, which is already connected to the control, is
connected to the relevant and marked ground wire end on the irradiation chamber
before the UV system is put into use. Check whether the irradiation chamber has a
good electrical connection with the ground contact in the plug.
●
5692 DH Son Netherlands
Installation & User Manual
Drawing 12
●
●
+31 499 461099
info@vgebv.nl
VGEM000-GB192
●
www.vgebv.nl
Pag. 45/68