Routine Servicing Instructions
1. Remove electrode B.
2. Release the three Torx screws, and
remove thermal insulating ring C.
3. Release the four Torx screws, and
remove burner gauze assembly D
with its gasket E.
Checking and adjusting the ignition and ionisation electro-
des
A Ignition and ionisation electrode
1. Check the electrode for wear and
contamination.
Service Instructions
(Fortsetzung)
4. Insert and secure a new burner
gauze assembly D with a new
gasket E.
5. Refit the thermal insulation ring C.
6. Refit the electrode B.
2. Clean the electrode with a small
brush (not with a wire brush) or
emery paper.
55