Table of Contents
Advertisement
Section 7 - Lubrication and Maintenance
Engine Oil
A. Engine Oil Level Check
2
1. Perform "Shut-Down Procedure" on page 4-4.
2. Remove dipstick (1) and check oil mark. The oil should be between the full (2)
and add (3) marks within the crosshatched area of the dipstick.
3. If oil is low, open the engine cover, remove oil fill cap (4) and add motor oil to
bring oil up to the full mark in the crosshatch area.
4. Replace oil fill cap and dipstick.
5. Close and secure the engine cover.
Note: The standard service interval for engine oil and filter is 250 hours maximum.
If an extended service interval is desired, see your engine manual for specific
guidelines for optimizing oil change intervals.
7-12
JOHN DEERE ENGINE
3
CUMMINS ENGINE
4
1
10
4
1
2
3
31200172
Advertisement
Table of Contents
