Table of Contents
Advertisement
The joystick (1) controls lift/lower and extend/retract movement of the boom.
The tilt lever (2) controls the mast tilt.
• Move lever back to tilt up.
• Move lever forward to tilt down.
To Raise/Lower Mast:
The auxiliary hydraulic lever (3) controls the raise/lower movement of the mast.
• Move lever up to lower.
• Move lever down to raise.
Installation Procedure:
Refer to "Attachment Installation" on page 5-11.
CRUSH HAZARD. Do not use mast to push or pull objects or load. Failure to
comply could cause object or load to fall.
Operation:
• Always lower forks fully in mast before engaging load.
• To drive with a load, lower forks fully in mast and travel in accordance with the
requirements set forth in Section 1 - General Safety Practices.
• Use a signal person to assist in positioning of load if necessary.
Equipment Damage Precautions:
• Do not use forks as a lever to pry material. Excessive prying forces could
damage forks or machine structure.
• Do not attempt to lift loads that are attached or connected to another object.
31200172
WARNING
Section 5 - Attachments
5-25
Advertisement
Table of Contents
