Table of Contents
Advertisement
The joystick (1) controls lift/lower and extend/retract movement of the boom.
The tilt lever (2) controls the carriage tilt.
• Move lever back to tilt up.
• Move lever forward to tilt down.
To Side Tilt:
The auxiliary hydraulic lever (3) controls the carriage side tilt.
• Move lever up to (side) tilt left.
• Move lever down to (side) tilt right.
Installation Procedure:
• Refer to "Attachment Installation" on page 5-11.
CRUSH HAZARD. Do not use side tilt to push or pull objects or load. Failure to
comply could cause object or load to fall.
Operation:
• Approach load with forks centered on load and stop telehandler.
• Level telehandler before side tilting carriage to engage load.
• Side tilt carriage to left or right to align forks with load and engage load.
• Raise load slightly and level carriage side to side.
• Travel in accordance with the requirements set forth in Section 1 - General
Safety Practices.
Equipment Damage Precautions:
• Do not use forks as a lever to pry material. Excessive prying forces could
damage forks or machine structure.
• Do not attempt to lift loads that are attached or connected to another object.
31200172
WARNING
Section 5 - Attachments
5-21
Advertisement
Table of Contents
