VIVAX
INFORMATION
ECO MODE SET have two kinds of curves:
1. the curve of the high temperature
setting for heating,
2. the curve of the low temperature
setting for heating,
It only have the curve of the high
temperature setting for heating, if the high
temperature is set for heating.
See ''FOR SERVICEMAN''>''HEAT MODE
SETTING'' in "Installation and owner's
manual (M‐thermal split indoor unit)".
The desired temperature (T1S) can't be
adjusted, when the ECO mode is ON.
You can selet the low or hige temperature
setting for heating to see the "Table 1~2".
If HEAT MODE is ON and ECO TIMER is
OFF,the unit run ECO mode all the time.
If HEAT MODE is ON and ECO TIMER is
ON,the unit run ECO mode according to
the start time and end time.
DOMESTIC
(DHW)
DHW mode typically consists of the
following :
1) DISINFECT
2) FAST DHW
3) TANK HEATER
4) DHW PUMP
Disinfect
The DISINFECT function is used to kill the
legionella.In disinfect function the tank
temperature will be reached 65~70 forcely.
The disinfect temperature is set in FOR
SERCICEMAN.
See DISINFECT in Installation and Ower's
manual.
Go to ''MENU'' > ''DOMESTIC HOT WATER'' >
''DISINFECT''.
Press ''OK''. The following page will appear
HOT
WATER
Use ''◄'',''► '', ''▼ '', ''▲'' to scroll and use
''▼'', ''▲'' to adjust the parameters when
setting ''OPERATE DAY'' and ''START''.
If the OPERATE DAY is set FRIDAY and the
START is set 23:00, the disinfect function will
active on 23:00 Friday.
If CURRENT STATE is OFF, DISINFECT is
invalid.
If the disinfect function is running, the
following page will appear:
16
ENG