Table of Contents
Advertisement
Only qualified personnel should install the SWPIM-DDS.
This chapter covers the following items:
•
Unpacking the SWPIM-DDS
•
Installing the SWPIM-DDS into the host platform
•
A description of the LANVIEW LED indications
•
Connecting the SWPIM-DDS to the network
•
What to do once the SWPIM-DDS is installed
1.1
UNPACKING THE SWPIM-DDS
Use static electricity precautions when handling the SWPIM-DDS.
Failure to observe static safety precautions could cause
!
damage to the SWPIM-DDS. Follow static safety handling rules
CAUTION
and wear the antistatic wrist strap shipped with the
SWPIM-DDS.
1.
Open the packing box and remove the SWPIM-DDS.
Do not cut the non-conductive bag to remove the device.
!
Damage could result from sharp objects contacting the device
CAUTION
or components.
2.
Attach the antistatic strap (refer to the instructions in the antistatic
wrist strap package) before removing the SWPIM-DDS from the
antistatic packaging.
3.
Verify that the SWPIM-DDS is undamaged. Refer to
there is any damage to the device. Do not attempt to install the
SWPIM-DDS if it is damaged.
SWPIM-DDS Installation Guide
CHAPTER 1
INSTALLATION
(Section
1.1)
(Section
(Section
(Section
(Section
Getting Help
1.2)
1.3)
1.4)
1.5)
if
1-1
Advertisement
Table of Contents
